TONE MONSTER SEB3-AB Guitar Bass Preamp Balance Volume Treble/Bass Middle 4 Pots

Description

BUILD A
TONE
MONSTER!
SEB3-AB
Balance~Volume~Treble/Bass~Middle
The
TONE
MONSTER
SEB Series
preamps are a cost-effective solution for any instrument equipped with either magnetic or piezoelectric pickups. With a +/- 12dB range for either two (treble/bass) or three (treble/middle/bass) bands of equalization, they are pre wired and ready to install. Best of all they will bring your passive pickups to life! Features include brass shaft potentiometers and a balance potentiometer with a
NO SOLDER
terminal block for easy pickup connection (neck~shared ground~bridge). For single pickup or pickup selector switch applications simply remove the balance potentiometer.
The
SEB Series
also features a gain trim potentiometer mounted right on the circuit board (small blue cube) so you can increase or decrease the incoming signal based on the pickup(s) being used.
SEB PA+
model features the
PPB v.1
passive/active volume upgrade with or without a passive tone control.
The
PTE
(Passive Tone Enhancer) upgrade replaces the standard passive tone potentiometer with a bypass position along with 5 filters which cut or remove specific frequencies.
The mid frequency toggle feature (
MT
) allows you to select from 250, 500 or 800Hz.
The circuit board, manufactured using
Surface Mount Technology (SMT)
, is covered in epoxy to prevent damage and secure the wiring. Top quality components
and meticulous soldering ensures noise free performance. The plastic case (45 X 25 mm) includes an adhesive pad for secure mounting. Powered by a 9V alkaline battery (not included) the circuit can handle up to 18V (2-9V in series) for increased headroom. We offer DIY power upgrades including the
BAT-1
(18V) or
BAT-2
(9 or 18V switchable).
We suggest using pickups with similar outputs, either magnetic or piezoelectric, but not both together since the balance (blend) function is passive. Also, our preamps were designed for use and work best with passive pickups.
SEB-AB -
concentric (stacked) treble/bass potentiometer to reduce the number of controls
SEB-B
– standard configuration with brass shaft potentiometers for longer life and smoother control
PA+
- passive/active push/pull volume & tone control
MT
- middle frequency toggle
PTE
- Passive Tone Enhancer (
see our eBay store
)
FEATURES:
Manufactured in South Korea
Pre wired harness ready to install
Brass shaft potentiometers for smoother control and longer life
Center detent on balance and tone potentiometers
+/-12dB range for 2 or 3 bands of equalization
Configurations from 3 to 6 potentiometers
Gain trim potentiometer for level adjustments
Balance potentiometer with a
NO SOLDER
terminal block
DIY upgrades (BAT1/BAT2) available for 18V power
Bass: +/-12 dB at 100 Hz
Middle +/- 12dB at 800 Hz (SEB3)
Treble: +/-12 dB at 4 kHz
Balance: MN500K w/center detent
Input Impedance: 1Mohm
Current: 0.16 mA
Voltage range: 6 ~ 22 volt
Battery Requirement: 9V alkaline
KNOBS ARE NOT INCLUDED!
Standard Potentiometers: 6mm
Concentric (stacked) Potentiometers: 6mm top / 8mm bottom
SEB SERIES PREAMP MODELS
SEB2-AB
(3 pots) Balance~Volume~Treble/Bass
SEB2-B
(4 pots) Balance~Volume~Treble~Bass
SEB3-AB
(4 pots) Balance~Volume~Treble/Bass~Middle
SEB3-B
(5 pots) Balance~Volume~Treble~Middle~Bass
PA+
- push/pull active/passive volume & tone*
MT
- middle frequency toggle
PTE
- Passive Tone Enhancer
*adds a potentiometer
----------------------------------------------------------------------------
Please note the following:
The seller reserves the right to cancel any and/or all bids at their discretion.
PayPal is the only form of payment and expected within 3 days of the end-of-auction.
A non-paying bidder report will be filed with eBay on the 4th day!
Orders will only be shipped to a confirmed PayPal address
unless arrangements are made prior to purchase.
IF YOU USE A U.S. ADDRESS AND/OR FORWARDING SERVICE TO MAKE YOUR PURCHASE AND
THERE IS AN ISSUE
WITH YOUR ORDER YOU ARE RESPONSIBLE FOR THE COST OF RETURN
.
The eBay system will only provide a return label for the U.S. address.
We will not ship a replacement or provide a refund until the return is received!